I did a little screen capture on how to go about this via Smaart. The data isn’t perfect but it never is…..

START OF PROCEEDINGS: NEVER SET UP YOU SPEAKERS LIKE THIS PLEASE!!!!!!

Did the same experiment with a Front Back Front set-up as the Gradient set-up in the blog post before this 1.

Also i wanted to see if this array would still work when positioned in close proximity of a wall (1mt from the back of the array in this case).

This is a follow up on the blog post prior to this 1.

So now the same set-up as before but not via cascading 2nd order All-pass filters but using all goodies available via FIR Designer M.

This is a follow up on the post on cascading 2nd order all pass filters https://timobeckmangeluid.wordpress.com/2021/03/15/cascading-2nd-order-all-pass-filters/

The same thing can be done via FIR.

Just messing around with idea’s for a advanced training 😉

Even 2 voorbeelden betreffende een sub top alignment waar ik voor nu alleen naar het fase gedrag kijk. (silent eq en meer van dat soort fraaie snufjes bewaar ik voor of een training of een latere screen-capture)

In dit geval is het een trainingsvoorbeeld en om de data makkelijk leesbaar te houden heb ik de top op de grond gelegd (zie foto).

Did a couple of posts some time ago on using multiple generators for at that time a surround set-up.

In this post i’m following up on those 2 posts (https://timobeckmangeluid.wordpress.com/2020/05/25/creating-mayhem/ https://timobeckmangeluid.wordpress.com/2020/05/30/creating-mayhem-part-2/)

I’m using a Left and Right system (Fulcrum Acoustic CCX1295 left and right main + 2 x CX896 for delays without the CSP121’s i have for low end active during the measurements).

I wanted to try a End Fired & Gradient/Reversed End Fired Array out of the Fulcrum Acoustic CS℗121 for a long time but never found the time to do it.

Yesterday I did.

After messing with the high driver (see the BLOG POST before this 1) I did a little experiment on the Low driver.

I tried to get as phase flat as possible without running a sh*t load of latency. Kinda worked 😉