Mapping again on a end fired array .   Leave a comment

So during the last seminar i gave i tried a end fired array with 6 subs on separate processor channels .

The measurement mic was of axis in order to stear the low end to the mic position  .

<a href=””&gt;end-fired-2_thumb2

I did the simulation on this array in map on line . Although it’s a simulation this is about the same as i experienced while aligning this array in a real live situation .

40HzEnd fired steering 40Hz  50HzEnd fired steering 50Hz  63HzEnd fired steering 63Hz  80HzEnd fired steering 80Hz  100HzEnd fired steering 100Hz  125HzEnd fired steering 125Hz

Needless to say : be carefull if you do this kind of an array .

Regards Timo Beckman .

Posted 28/10/2013 by timobeckmangeluid in Geen categorie

Geef een reactie

Vul je gegevens in of klik op een icoon om in te loggen. logo

Je reageert onder je account. Log uit / Bijwerken )


Je reageert onder je Twitter account. Log uit / Bijwerken )

Facebook foto

Je reageert onder je Facebook account. Log uit / Bijwerken )

Google+ photo

Je reageert onder je Google+ account. Log uit / Bijwerken )

Verbinden met %s

%d bloggers liken dit: